.	WELD INSPECTION GAUGES & EQUIPMENTS

E] V-WAC GAUGE The V-Wac Gauge easily and quickly checks the four essential measurements required for compliance with NCR Visual Weld Acceptance Criteria. Checks undercut depth, porosity comparison, amount of porosity per linear inch and crown height. The V-Wac Gauge can be purchased separately or as part of a complete set of seven Fillet Weld Gauges that determine if your welds conform to specifications. Features of the V-WAC Gauge Accurate : Undercut depth or crown height scale can be read to 1/32 inch. Porosity comparison of 1/8 inch and 1/16 inch. Linear gauge in 1/16 inch increments. Easy To Use : Pointer is easy to set and locking screw holds it in position for later reference. Figures and increments are etched into surface. They are easy to read and will not rub off. Fast : All required measurements are made with a Single gauge. Sturdy : Gauge is made of Stainless Steel. Handy : Gauge is 1-1/4" inches by 4" inches. Can be carried in Your pocket. 9] FERRITESCOPE®- MP 30 Make : Fischer Instrumentation (G.B.) Ltd , England TECHNICAL INFORMATION : The rugged FERITSCOPE® MP30 with plug-in type smart probe is suited for fast, non-destructive and accurate measurement of ferrite content on-site or in the lab according to the magnetic inductive method. The calibration of the FERITSCOPE® MP30 is traceable to internationally approved IIW secondary calibration standards. The instrument therefore meets all requirements of ANSI/AWS A4.2-91 and DIN 32 514 as well as of the "Basler" standard Applications : Measurement of the ferrite content in austenitic steel welds (of tubing etc.), normal construction steel with austenitic chrome alloy steel welded cladding (e.g., in boilers, vessels, etc.) and duplex steel. Features : • Non Destructive Measurement of the ferrite content in a range of 0.1 to 110 FN or0.1 to 80% Fe in austenitic and duplex steel. • Memory capacity for max. 10,000 measurements • Measurements are traceable using certified calibration standards • Measurement units are selectable between WRC-FN and % FE • Available are standard, right angle and inside probes For more details please contact eastwestndt@vsnl.com 10] ELCOMETER FERRITE GAUGE MODEL : A111 7F For determining the ferrite content in stainless steel. Operates on a magnetic principle. Several models available. Specifications : • Size - 9" x 2" x 1" Model                                          Model No.                      Range/ Size Inspector Ferrite Gage          111/7F            0 - 30FN (Direct Reading)